Monday, 19 October 2009 11:50

Geothermal Energy - How Does it Work?

Written by  Earth Talk
Rate this item
(0 votes)

A utility-grade geothermal energy plant in Iceland, which derives 26.5 percent of its electricity needs from the technology - Photo By Gretar IvarssonThe term “geothermal” is derived from the Greek words for Earth (geo) and heat (therme). In essence geothermal energy is power harnessed from the Earth itself. Heat from the Earth’s core, which averages about 6,650 degrees Fahrenheit, emanates out toward the planet’s surface. Heated springs and geysers up to three miles underground can be accessed by special wells that bring the hot water (or steam from it) up to the surface where it can be used directly for heat or indirectly to generate electricity by powering rotating turbines. Since the water under the Earth’s surface is constantly replenished, and the Earth’s core will continue to generate heat indefinitely, geothermal power is ultimately clean and renewable.

Today there are three main methods for harvesting utility-grade geothermal energy: dry steam, flash steam and binary-cycle. The dry steam process brings steam up directly from below to drive turbines that power electricity generators. Flash steam plants bring the hot water itself up from below; it is then sprayed into a tank to create steam to drive the turbines. These two methods are the most common, generating hundreds of megawatts of electricity across the American West, Europe and elsewhere. But expansion is limited as these plants only work in tectonic regions where it is easier to access ground heated water.

The binary-cycle technology extracts close-to-the surface warm (not necessarily hot) water and combines it with a second (“binary”) fluid, like butane or pentane, which has a low boiling point. This fluid is then pumped through a heat exchanger, where it is vaporized and sent through a turbine before being recycled back into the system. Binary-cycle geothermal plants already pump out dozens of megawatts of electricity in California, Nevada and Hawaii, among other places.

But geothermal isn’t just for utilities. Homeowners looking to go green and lower their utility bills can install a residential system, essentially a scaled-down version of the binary-cycle system. A series of pipes is installed underground. Water circulating in the loop is heated naturally underground and then transferred to a heat exchanger which concentrate the energy and releases it inside the home as heat. In summer and in warmer climates, the process is reversed to fill the home with geothermal-cooled air.

Read 1629 times

Community News

Clearwater Dolphins - Leave a Map-Trail
Although fans are sad to see the Clearwater Beach Dolphin…
Stingray Season Has Started Early
Stingray season has started early this year. Three people were…
Sea Turtle Nesting Season Begins May 1st
Sea turtle nesting season begins May 1 and ends Oct.…
Middle School Students Donate $650 to Clearwater Marine Aquarium's Rescued Sea Turtles
Kids in “Friends for Florida” presented $650 to Clearwater Marine…
International Celebrate CMA and Winter Day
Clearwater Marine Aquarium (CMA) fans Jenna Deedy (from New Hampshire)…
Winter the Dolphin Gets New Home as Clearwater Marine Aquarium Expands
On the exact day of the 38th anniversary the Clearwater…
Mutt Strut Raises Money for Humane Society of Pinellas
The Humane Society of Pinellas held their signature event, the…
Embrace Diversity - End Discrimination
Every five seconds during the school day, an African American…